IGMP COMMANDS
552
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
igmp proxy config
Configure the IGMP proxy.
SYNTAX:
igmp proxy config [state = <{disabled|enabled}>]
[qi = <number{1-31744}>]
[qri = <number{1-3175}>]
[lmqi = <number{1-3175}>]
[rv = <number{2-7}>]
[advinter = <number{4-180}>]
[initadvinter = <number{1-4}>]
[initadvcount = <number{1-10}>]
[requirera = <{disabled|enabled}>]
[localgroup = <{disabled|enabled}>]
where:
state Enable/Disable the IGMP proxy. OPTIONAL
qi The interval in seconds between general queries sent by the
querier.
OPTIONAL
qri The maximum response time in seconds for an IGMP client
in reply to general queries.
OPTIONAL
lmqi The maximum response time in seconds for an IGMP client
in reply to group specific queries.
OPTIONAL
rv The robustness variable allows tuning for expected IGMP
packet loss.
OPTIONAL
advinter The interval in seconds for unsolicited MRD advertisements
(see rfc4286).
OPTIONAL
initadvinter The interval in seconds for initial unsolicited MRD
advertisements (see rfc4286).
OPTIONAL
initadvcount The maximum number of initial unsolicited MRD
advertisements (see rfc4286).
OPTIONAL
requirera Enable/Disable the router alert IP option check. OPTIONAL
localgroup Enable/Disable the processing of a local multicast group in
an IGMP packet.
OPTIONAL