ETH COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
473
eth switch shaper config
Configure common ingress shaper parameters.
SYNTAX:
eth switch shaper config shaper = <number{0-1}>
[unicast = <{enabled|disabled}>]
[multicast = <{enabled|disabled}>]
[broadcast = <{enabled|disabled}>]
[control = <{enabled|disabled}>]
[unknown = <{enabled|disabled}>]
[discard = <{enabled|disabled}>]
[normalize = <{enabled|disabled}>]
[exclude_ipg = <{enabled|disabled}>]
where:
shaper The shaper instance. REQUIRED
unicast Shape unicast traffic. OPTIONAL
multicast Shape multicast traffic. OPTIONAL
broadcast Shape broadcast traffic. OPTIONAL
control Shape MAC control traffic. OPTIONAL
unknown Shape traffic with unknown destination address. OPTIONAL
discard Discard frame at overflow (else attempt for flow control). OPTIONAL
normalize Use relative speed calculations. OPTIONAL
exclude_ipg Exclude the Inter Packet Gap in the speed calculations. OPTIONAL
To Next Page
Loading...
Need help?
General
