ETH COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
401
eth device ifconfig
Configure an Ethernet port's type setting (disable/enable autonegotiation).
SYNTAX:
eth device ifconfig intf = <{ethif1|ethif2|ethif3|ethif4|ethif5|}>
[state = <{enabled|disabled}>]
[type = <{auto|10BaseTHD|10BaseTFD|100BaseTHD|
100BaseTFD}>]
[mtu = <number{1518-1534}>]
where:
intf The Ethernet port's name. REQUIRED
state The port's administrative state. OPTIONAL
type The port's type setting. If auto, then autonegotiation will
be used, if something else, then autonegotiation will be
disabled. Be careful with using this command: a wrong
type setting make you loose the link. Use the autonegotian
settings command instead: this is much more reliable!
OPTIONAL
mtu The MTU for this Ethernet port. OPTIONAL
To Next Page
Loading...
Need help?
General
