ETH COMMANDS
474
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth switch shaper ifconfig
Configure per port shaper parameters.
SYNTAX:
eth switch shaper ifconfig port = <number{1-5}>
ingress = <{enabled|disabled}>
shaper = <number{0-1}>
[state = <{enabled|disabled}>]
[speed = <number{64000-1000000000}>]
[burstsize = <{16|20|28|40|76|140|268|500}>]
where:
port The port. REQUIRED
ingress Ingress port = enabled; egress port = disabled. REQUIRED
shaper The shaper instance. REQUIRED
state Enable/disable shaping. OPTIONAL
speed Speed in bits/sec. OPTIONAL
burstsize Burst size in KBytes. OPTIONAL
To Next Page
Loading...
Need help?
General
