IP COMMANDS
570
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
ip auto ifconfig
Configures an autoIP interface.
SYNTAX:
ip auto ifconfig intf = <>
[addr = <ip-address>]
[poolstart = <ip-address>]
[poolend = <ip-address>]
[netmask = <ip-mask(dotted or cidr)>]
[claim = <number{0-65535}>]
[defence = <number{0-65535}>]
[probe = <number{0-65535}>]
[interval = <number{1-65535}>]
where:
intf The name of the autoIP interface to configure. REQUIRED
addr The preferred link-local IP address. OPTIONAL
poolstart The start IP address of the link-local address pool. OPTIONAL
poolend The end IP address of the link-local address pool. OPTIONAL
netmask The netmask of the link-local IP address pool. OPTIONAL
claim The number of link-local address selection retries before
giving up.
OPTIONAL
defence The number of times the link-local address is defended
before releasing the address.
OPTIONAL
probe The number of ARP probes to be sent before accepting a
link-local address.
OPTIONAL
interval The time interval between two ARP probe transmissions. OPTIONAL
To Next Page
Loading...
Need help?
General
