ROUTER COMMANDS
878
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
router ospf area config
Configures an OSPF area
SYNTAX:
router ospf area config id = <ip-address>
[priority = <number{0-255}>]
[hello_interval = <number{1-3600}>]
[dead_interval = <number{1-3600}>]
[ase_pref = <number{0-255}>]
where:
id The unique id of this OSPF Area. A value of 0.0.0.0 signals
that the area is a backbone area.
REQUIRED
priority Specifies the priority for becoming the designated router.
This parameter only applies for broadcast media
OPTIONAL
hello_interval Specifies the time between hello packets in seconds OPTIONAL
dead_interval Specifies the number of seconds which may elaps without
receiving a hello packet before declaring it down
OPTIONAL
ase_pref Sets the M-RIB preference for OSPF ASE routes . Default
preference value is 10
OPTIONAL
To Next Page
Loading...
Need help?
General
