FIREWALL COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
521
firewall rule modify
Modify a rule.
SYNTAX:
firewall rule modify chain = <chain name>
[index = <number>]
[newindex = <number>]
[name = <string>]
[clink = <chain name>]
[[!]srcintf] = <chain name>]
[[!]srcip] = <chain name>]
[[!]dstintf] = <chain name>]
[[!]dstip] = <chain name>]
[[!]serv] = <chain name>]
[[!]length] = <chain name>]
[log = <{disabled|enabled}>]
[state = <{disabled|enabled}>]
[action = <{accept|deny|drop|reset|count|
link}>]
where:
chain The name of the chain which contains the rule. REQUIRED
index The index of the rule in the chain. OPTIONAL
newindex The new index of the rule in the chain. OPTIONAL
name The name of the new rule. OPTIONAL
clink The name of the chain to be parsed when this rule applies. OPTIONAL
[!]srcintf] The name of the source interface expression.
If a value is preceded by a “!”, it means NOT.
OPTIONAL
[!]srcip] The name of the source ip expression.
If a value is preceded by a “!”, it means NOT.
OPTIONAL
[!]dstintf] The name of the destination interface expression.
If a value is preceded by a “!”, it means NOT.
OPTIONAL
[!]dstip] The name of the destination ip expression.
If a value is preceded by a “!”, it means NOT.
OPTIONAL
[!]serv] The name of the service expression.
If a value is preceded by a “!”, it means NOT.
OPTIONAL
[!]length] The name of the length expression.
If a value is preceded by a “!”, it means NOT.
OPTIONAL
To Next Page
Loading...
Need help?
General
