IPSEC COMMANDS
666
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
ipsec peer modify
Changes a peer gateway profile.
SYNTAX:
ipsec peer modify name = <>
[remoteaddr = <IP address or hostname>]
[backupaddr = <IP address or hostname>]
[exchmode = <{main|aggressive}>]
[localid = <Identity : format(type)value; type
being >]
[remoteid = <Identity : format(type)value;
type being >]
[phyif = <{loop|Internet|lan1|wan1|dmz1|
guest1|any}>]
[descr = <{AES_SHA1|AES_MD5|3DES_SHA1|
3DES_MD5|DES_SHA1|DES_MD5|AES_SHA1_Adv|
3DES_SHA1_Adv}>]
[auth = <>]
[client/server = <>]
[options = <>]
where:
name The name of the peer profile to change. REQUIRED
remoteaddr Black IP address/hostname of the peer IPSEC gateway. OPTIONAL
backupaddr Black IP address/hostname of the redundant peer IPSEC
gateway.
OPTIONAL
exchmode Authenticated key exchange mode. OPTIONAL
localid The ID by which the peer gate identifies this gate. OPTIONAL
remoteid The ID of the peer gate. OPTIONAL
phyif Interface this peer applies to. OPTIONAL
descr Up to 4 phase one (ISAKMP) security descriptors separated
by |
OPTIONAL
auth Authentication attribute. OPTIONAL
client/server VPN dialup client/server descriptor. OPTIONAL
options Peer options. OPTIONAL
To Next Page
Loading...
Need help?
General
