ETH COMMANDS
438
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth ifconfig
Modify an ETH interface.
SYNTAX:
eth ifconfig intf = <{ethoa_8_35|eth_ge|eth_dmz1|
eth_guest1|eth_wan1}>
[dest = <{bridge|ethoa_8_35|eth_ge|eth_dmz1|
eth_guest1|eth_wan1}>]
[retry = <number{0-65535}>]
[wan = <{disabled|enabled}>]
[priotag = <{disabled|enabled}>]
[mtu = <number{1500-1508}>]
[vlan = <{default|wan|dmz|guest}>]
where:
intf The name of the ETH interface to configure. REQUIRED
dest The destination interface for this ETH interface. OPTIONAL
retry The number of times the ETH connection setup should
retry before giving up.
OPTIONAL
wan Enable/Disable WAN for this ETH interface. OPTIONAL
priotag Enable/Disable VLAN priority tagging. OPTIONAL
mtu The MTU for this ETH interface. OPTIONAL
vlan The VLAN for this ETH interface. OPTIONAL
To Next Page
Loading...
Need help?
General
