ETH COMMANDS
360
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth bridge filter ifdel
Remove an interface from a filter.
SYNTAX:
eth bridge filter ifdel brname = <{bridge}>
name = <{}>
intf = <{OBC|ethport1|ethport2|ethport3|
ethport4|WLAN|virt|vdsl2}>
where:
brname The name of an bridge. REQUIRED
name The name of the filter to configure. REQUIRED
intf The name of the bridge interface to remove. REQUIRED
To Next Page
Loading...
Need help?
General
