ROUTER COMMANDS
896
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
router rip ifconfig
Configs an interface the RIP daemon will run on
SYNTAX:
router rip ifconfig intf = <{Internet|dmz1|guest1|ipsec0|lan1|
wan1}>
[ripin = <{disabled|enabled}>]
[ripout = <{disabled|enabled}>]
[metricin = <number{1-16}>]
[metricout = <number{0-16}>]
[version = <{v1|v2|v2_broad}>]
[state = <{disabled|enabled}>]
where:
intf Specifies the physical interface to configure. REQUIRED
ripin Configures wether or not received RIP updates or going to
be processed.
OPTIONAL
ripout Configures wether or not RIP updates or going to be sent. OPTIONAL
metricin Specifies the in-metric OPTIONAL
metricout Specifies an additional cost on outgoing interfaces OPTIONAL
version Specifies the version which will be run on the interface OPTIONAL
state Enable/Disable RIP on an interface OPTIONAL
To Next Page
Loading...
Need help?
General
