ROUTER COMMANDS
880
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
router ospf area ifadd
Adds an interface to an area
SYNTAX:
router ospf area ifadd id = <ip-address>
intf = <{ipsec0|Internet|lan1|wan1|dmz1|
guest1}>
[passive = <{disabled|enabled}>]
where:
id The unique id of this OSPF Area. A value of 0.0.0.0 signals
that the area is a backbone area.
REQUIRED
intf Specifies the IP-Interface name. REQUIRED
passive Specifies wether or not to send or receive packets on this
interface
OPTIONAL
To Next Page
Loading...
Need help?
General
