03/2003
iii
8850/ 510DP
About this Manual, Organization
Introduction
About this Manual
This manual is part of a documentation system that includes the training.
This manual contains Repair Analysis Procedures (RAPs), Repair Procedures, Adjustment
Procedures, Parts List, Diagnostic Procedures, Installation Procedures, Wiring Data and
BSDs.
This manual will enable the Service Representative to repair the 8850 printer.
Organization
This manual consists of eight sections. The title and description of each section are listed
below.
Section 1. - Service Call Procedures
This section contains the following:
• Call Flow Procedure
• Initial Actions/ System Checks
• Print Defect Isolation Procedure
• Workstation Checkout Procedure
• Status Code Entry Chart
• Message Display Entry Chart
• Maintenance Procedures
• Callback
• System Checkout/ Final Action
Call Flow Procedure
The Call Flow Procedure is a list of activities to be performed on each service call.
Initial Actions/ System Checks
This procedure is designed to identify and classify the problem and to refer you to the appropri-
ate RAP in order to repair the problem. When the problem has been repaired, perform the Final
Action.
Print Defect Isolation Procedure
This procedure directs the CSE to make test prints, perform test procedures to identify the
cause of a print defect.
Workstation Checkout Procedure
This procedure is designed to ensure that the printer is correctly set up to run and communi-
cate with other elements. It consists of a series of connection checks, configuration test prints,
PING tests, and tests made from a laptop PC.
Status Code Entry Chart
This table provides a list of status codes, a description of the problem, the components that
are affected, RAPs that may resolve the problem, as well as BSD references and Parts List ref-
erences.
Message Display Entry Chart
This table contains a list of messages that may be generated by the printer, their cause, clear-
ance procedures, and BSD references.
Maintenance Procedures
The Maintenance Procedures identifies functional checks and cleaning operations that must
be performed on every Normal Call. It also identifies those activities that can be performed as
needed or as scheduled.
To Next Page
Loading...
Need help?
General