52-89
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 52 Configuring QoS
Configuring QoS on the Switch
Configuring QoS Statistics Data Export
These sections describe how to configure the QoS statistics data export feature:
• Enabling QoS Statistics Data Export Globally, page 52-89
• Enabling Per-Port QoS Statistics Data Export, page 52-90
• Enabling Per-Aggregate Policer QoS Statistics Data Export, page 52-91
• Clearing the Aggregate Policer QoS Statistics, page 52-92
• Setting the QoS Statistics Data Export Time Interval, page 52-92
• Configuring the QoS Statistics Data Export Destination Host and UDP Port, page 52-93
• Displaying the QoS Statistics, page 52-93
Enabling QoS Statistics Data Export Globally
To export the QoS statistics data for the ports and the aggregate policers, you must first configure the
feature globally.
To enable QoS statistics data export globally, perform this task in privileged mode:
This example shows how to enable QoS statistics data export globally and verify the configuration:
Console> (enable) set qos statistics export enable
Export is enabled.
Export destination:172.20.52.3 SYSLOG facility LOG_LOCAL6 (176), severity LOG_DE
BUG (7)
Aggregate policer export is not supported
Console> (enable) show qos statistics export info
Statistics export status and configuration information
------------------------------------------------------
Export status: enabled
Export time interval: 300
Export destination:172.20.52.3 SYSLOG facility LOG_LOCAL6 (176), severity LOG_DE
BUG (7)
Port Export
------ --------
1/1 disabled
1/2 disabled
3/1 disabled
3/2 disabled
5/1 disabled
5/2 disabled
5/3 disabled
5/4 disabled
<...output truncated...>
Console> (enable)
Task Command
Step 1
Enable QoS statistics data export. set qos statistics export enable | disable
Step 2
Verify the configuration. show qos statistics export info
To Next Page
Loading...
Need help?
General