Cisco WS-C6506 User Manual

55-29
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 55 Configuring a VoIP Network
Configuring VoIP on a Switch
3/19 onhook 1 full 64k FXS
3/20 onhook 1 full 64k FXS
3/21 onhook 1 full 64k FXS
3/22 onhook 1 full 64k FXS
3/23 onhook 1 full 64k FXS
3/24 onhook 1 full 64k FXS
Port DHCP MAC-Address IP-Address Subnet-Mask
-------- ------- ----------------- --------------- ---------------
3/1-24 enable 00-10-7b-00-13-e4 172.20.34.50 255.255.255.0
Port Call-Manager(s) DHCP-Server TFTP-Sever Gateway
-------- ----------------- --------------- --------------- ---------------
3/1-24 172.20.34.207 172.20.34.207 172.20.34.207 -
Port DNS-Server(s) Domain
-------- ----------------- -------------------------------------------------
3/1-24 172.20.34.207* cisco.com
172.34.23.111
Port CallManagerState DSP-Type
-------- ---------------- --------
3/1-24 registered C549
Port ToneLocal Impedance InputGain(dB) OutputAtten(dB)
-------- ------------- --------- ------------- ---------------
3/1-24 northamerica 0 0 0
Port RingFreq Timing Timing Timing Timing
(Hz) Digit(ms) InterDigit(ms) Pulse(ms) PulseDigit(ms)
-------- -------- --------- -------------- --------- --------------
3/1-24 20 100 100 0 0
(*): Primary
Console> (enable)
Displaying the Active Call Information
Enter the show port voice active command to display the active call information on a port. There are up
to 8 calls per port for the 8-port T1/E1 PSTN interface module but only one call per port for the 24-port
FXS analog station interface module.
To display the active call information, perform this task in normal mode:
Entering the show port voice active command without any parameters shows all the calls in the system
(regular calls, conference calls, and transcoding calls). The display field descriptions are as follows:
• Type—The “call” notation is for the 24-port FXS analog interface module and 8-port PSTN
interface module calls.
When you configure the 8-port T1/E1 PSTN interfaces for transcoding and/or conferencing, the
Type field displays “conferencing” for conferencing calls and “transcoding” for transcoding calls.
• Conference-ID, Transcoding-ID, and Party-ID are applicable only to the 8-port T1/E1 PSTN
interfaces that are configured for transcoding and/or conferencing.
Task Command
Display the active call information. show port voice active [mod/port]
[all | call | conference | transcode] [ipaddr]

Cisco WS-C6506 Specifications

General

Brand	Cisco
Model	WS-C6506
Category	Switch
Language	English