14-24
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 14 Configuring MLS
Configuring MLS
This example shows how to display IPX MLS information:
Console> (enable) show mls ipx
IPX Multilayer switching aging time = 256 seconds
IPX flow mask is Destination flow
IPX max hop is 15
Active IPX MLS entries = 356
IPX MSFC ID Module XTAG MAC Vlans
--------------- ------ ---- ----------------- ----------------
22.1.0.56 15 1 00-10-07-38-29-18 2,3,4,5,6,
7,8,9,10,11,
12,13,14,15,16,
17,18,19,20,66,
77
00-d0-d3-9c-e3-f4 25
00-10-07-38-29-18 26,111
00-d0-d3-9c-e3-f4 112
22.1.0.58 16 2 00-10-07-38-22-22 2,3,4,5,6,
7,8,9,10,11,
12,13,14,15,16,
17,18,19,20
00-d0-d3-33-17-8c 25
00-10-07-38-22-22 26,66,77,88,99,
111
00-d0-d3-33-17-8c 112
Console> (enable)
Displaying IP MLS Cache Entries
These sections describe how to display the MLS cache entries on Supervisor Engine 1:
• Displaying All MLS Entries, page 14-25
• Displaying MLS Entries for a Specific IP Destination Address, page 14-25
• Displaying IPX MLS Entries for a Specific IPX Destination Address, page 14-26
• Displaying MLS Entries for a Specific IP Source Address, page 14-26
• Displaying MLS Entries for a Specific IP Flow, page 14-27
• Displaying IPX MLS Entries for a Specific MSFC, page 14-27
• Displaying MLS Entries for Bridged-Flow Statistics, page 14-28
Note For a description of how the flow mask mode affects the screen displays when showing the MLS entries,
see the “Flow Mask Modes and show mls entry Command Outputs” section on page 14-9.
To Next Page
Loading...
Need help?
General