17-9
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 17 Configuring GVRP
Configuring GVRP on the Switch
This example shows how to disable GVRP on 802.1Q trunk port 1/1:
Console> (enable) set gvrp disable 1/1
GVRP disabled on 1/1.
Console> (enable)
Disabling GVRP Globally
To disable GVRP globally on the switch, perform this task in privileged mode:
This example shows how to disable GVRP globally on the switch:
Console> (enable) set gvrp disable
GVRP disabled
Console> (enable)
Task Command
Disable GVRP on the switch. set gvrp disable
To Next Page
Loading...
Need help?
General