18-4
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 18 Configuring MVRP
Configuring MVRP on the Switch
Console> (enable) show mvrp configuration
Global MVRP Configuration:
MVRP Feature is currently enabled on the switch.
MVRP dynamic VLAN creation is disabled.
Port based MVRP Configuration:
MVRP-Status Registration Applicant Port(s)
----------- ------------ --------- ------------
Enabled Normal Normal 3/1-10,3/14,3/24
Disabled Normal Normal 2/2-3,3/11-13,3/15-23,3/25-48
Disabled Fixed Normal 2/1
Trunk based MVRP Configuration:
MVRP-Status Registration Applicant Trunk(s)
----------- ------------ --------- ------------
Enabled Normal Normal 3
Disabled Normal Normal 2
MVRP Timers(centiseconds):
-------------------------
JoinTimer LvTimer LvAllTimer Port(s)
--------- ------- ---------- --------
30 600 1000 3/1
200 600 1000 3/2
200 600 1000 3/3
200 600 1000 3/4
200 600 1000 3/14
200 600 1000 3/24
Console>
Enabling MVRP on Individual Trunk Ports
Note You can change the per-trunk MVRP configuration even if MVRP is enabled globally. However, MVRP
does not function on any ports until you enable it globally. For information on configuring MVRP
globally on the switch, see the “Enabling MVRP Globally” section on page 18-3.
You can enable MVRP on any of the individual trunk ports, regardless of the global MVRP enable state.
However, in order for the port to transmit and receive MVRP data, and become an active MVRP
participant, you must enable MVRP globally.
To enable MVRP on the individual trunk ports, perform this task in privileged mode:
This example shows how to enable MVRP on individual trunk port 3/1:
Console> (enable) set port mvrp 3/1 enable
MVRP enabled on 3/1.
Console> (enable)
Task Command
Step 1
Enable MVRP on an individual trunk port. set port mvrp mod/port enable
Step 2
Verify the configuration. show mvrp configuration
To Next Page
Loading...
Need help?
General