16-16
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 16 Configuring NDE
Configuring NDE on the Switch
This example shows how to clear the NDE flow filter so that all the flows are exported:
Console> (enable) clear mls nde flow
Netflow data export filter cleared.
Console> (enable)
Disabling NDE
Note With Supervisor Engine 1 and a PFC, if NDE is enabled and you disable MLS, you lose the statistics for
existing cache entries because the statistics are not exported.
To disable NDE on the switch, perform this task in privileged mode:
This example shows how to disable NDE on the switch:
Console> (enable) set mls nde disable
Netflow data export disabled.
Console> (enable)
Removing the NDE IP Address
To remove the NDE IP address from the MSFC, perform this task in global configuration mode:
This example shows how to remove the NDE IP address from the MSFC:
Router(config)# no mls nde-address 170.170.2.1
Router(config)#
Displaying the NDE Configuration
To display the NDE configuration on the switch, perform this task in privileged mode:
Task Command
Disable NDE on the switch. set mls nde disable
Task Command
Remove the NDE IP address from the
MSFC.
Router(config)# no mls nde-address [ip_addr]
Task Command
Display the NDE configuration on the
switch.
show mls nde
To Next Page
Loading...
Need help?
General