Cisco WS-C6506 User Manual

16-6
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 16 Configuring NDE
Default NDE Configuration
Default NDE Configuration
Table 16-5 shows the default NDE configuration.
14–15 output Egress interface SNMP ifIndex
XXXX
16–19 dPkts Packets in the flow
XXXX
20–23 dOctets Octets (bytes) in the flow
XXXX
24–27 First SysUptime at start of the flow
(milliseconds)
XXXX
28–31 Last SysUptime at the time the
last packet of the flow was received
(milliseconds)
XXXX
32–33 srcport Layer 4 source port number or equivalent
00XX
34–35 dstport Layer 4 destination port number
or equivalent
00XX
36 flags Flow mask in use
XXXX
37 tcp_flags Cumulative OR of TCP flags
0000
38 prot Layer 4 protocol
(for example, 6=TCP, 17=UDP)
00XX
39 tos IP type-of-service byte
XXXX
40–41 src_as Autonomous system number of the source,
either origin or peer
0000
42–43 dst_as Autonomous system number of the
destination, either origin or peer
0000
44 src_mask Source address prefix mask bits
0000
45 dst_mask Destination address prefix mask bits
0000
46–47 pad2 Pad 2 uses two bytes
48–51 MLS RP IP address of MLS router
X
3
X
2
X
2
X
2
1. This flow mask is not configurable from the CLI. It is only turned on if certain features, such as reflexive ACLs, are set up.
2. This feature is not supported on Supervisor Engine 1 or 1A.
3. For switched entries.
Table 16-4 NDE Version 7 Flow Record Format (continued)
Bytes Content Description
Flow masks: X=Populated
Destination
Destination
Source Full Full VLAN
1
Table 16-5 Default NDE Configuration
Feature Default Value
NDE Disabled
NDE data collector address and UDP port None specified
NDE filters None configured

Cisco WS-C6506 Specifications

General

Brand	Cisco
Model	WS-C6506
Category	Switch
Language	English