Cisco WS-C6506 User Manual

7-28
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 7 Configuring Spanning Tree
Configuring PVST+ on the Switch
Designated Root 00-60-70-4c-70-00
Designated Root Priority 16384
Designated Root Cost 19
Designated Root Port 2/3
Root Max Age 14 sec Hello Time 2 sec Forward Delay 10 sec
Bridge ID MAC ADDR 00-d0-00-4c-18-00
Bridge ID Priority 32769 (bridge priority: 32768, sys ID ext: 1)
Bridge Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Port Vlan Port-State Cost Prio Portfast Channel_id
------------------------ ---- ------------- --------- ---- -------- ----------
1/1 1 not-connected 4 32 disabled 0
1/2 1 not-connected 4 32 disabled 0
2/1 1 not-connected 100 32 disabled 0
2/2 1 not-connected 100 32 disabled 0
Configuring the PVST+ Port Cost
You can configure the port cost of switch ports. The ports with lower port costs are more likely to be
chosen to forward frames. Assign lower numbers to ports that are attached to faster media (such as full
duplex) and higher numbers to ports that are attached to slower media. The possible cost is from 1–65535
when using the short method for calculating port cost and from 1–200000000 when using the long
method. The default cost differs for different media. For information about calculating the port cost, see
the “Calculating and Assigning Port Costs” section on page 7-4.
To configure the PVST+ port cost for a port, perform this task in privileged mode:
Note When you enter the set spantree channelcost command, it does not appear in the configuration file. The
command causes a “set spantree portcost” entry to be created for each port in the channel. See the
“Setting the EtherChannel Port Path Cost” section in Chapter 6, “Configuring EtherChannel,” for
information on using the set spantree channelcost command.
This example shows how to configure the PVST+ port cost on a port and verify the configuration:
Console> (enable) set spantree portcost 2/3 12
Spantree port 2/3 path cost set to 12.
Console> (enable) show spantree 2/3
VLAN 1
.
.
.
Port Vlan Port-State Cost Prio Portfast Channel_id
------------------------ ---- ------------- --------- ---- -------- ----------
1/1 1 not-connected 4 32 disabled 0
1/2 1 not-connected 4 32 disabled 0
2/1 1 not-connected 100 32 disabled 0
2/2 1 not-connected 100 32 disabled 0
2/3 1 forwarding 12 32 disabled 0
2/4 1 not-connected 100 32 disabled
Task Command
Step 1
Configure the PVST+ port cost for a switch port. set spantree portcost {mod/port} cost
Step 2
Verify the port cost setting. show spantree mod/port

Cisco WS-C6506 Specifications

General

Brand	Cisco
Model	WS-C6506
Category	Switch
Language	English