20-38
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 20 Checking Status and Connectivity
Configuring Metro Ethernet Connectivity Fault Management
Displaying Ethernet OAM Statistics
To display OAM statistics, perform this task in normal mode:
This example shows how to display OAM statistics for port 1/2:
Console> (enable) show port ethernet-oam 1/2 statistics
Port InfoPduRx UniEventRx DupEventRx RLBCtrlRx VarReqRx VarResRx
----- ---------- ---------- ---------- ---------- ---------- ----------
1/2 2579 0 0 0 0 0
Port InfoPduTx UniEventTx DupEventTx RLBCtrlTx VarReqTx VarResTx
----- ---------- ---------- ---------- ---------- ---------- ----------
1/2 2571 0 0 1 0 0
Port OrgSpecRx UnknownRx CiscoPduRx CiscoTLVRx
----- ---------- ---------- ---------- ----------
1/2 0 0 0 1
Port OrgSpecTx UnknownTx CiscoPduTx CiscoTLVTx
----- ---------- ---------- ---------- ----------
1/2 0 0 0 0
Console> (enable)
Configuring Metro Ethernet Connectivity Fault Management
This section describes how to configure Metro Ethernet Connectivity Fault Management (CFM). CFM
is part of the Metro Ethernet OAM feature.
These sections describe how to configure Metro Ethernet CFM:
• Understanding How Metro Ethernet Connectivity Fault Management Works, page 20-39
• Connectivity Fault Management Protocols, page 20-39
• Maintenance Domains, page 20-39
• Maintenance Associations, page 20-40
• Maintenance Points, page 20-40
• CFM Configuration Guidelines and Restrictions, page 20-42
• Configuring Metro Ethernet CFM, page 20-44
• Understanding How CFM Works with 802.3ah Link-OAM for AIS-RDI, page 20-55
• Ethernet Alarm Indication Signal, page 20-55
• Ethernet Remote Defect Indication, page 20-56
• ASI and RDI Configuration Guidelines and Restrictions, page 20-56
• Configuring an Alarm Indication Signal, page 20-57
Task Command
Display OAM statistics. show port ethernet-oam [mod | mod/port]
statistics
To Next Page
Loading...
Need help?
General