8-13
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 8 Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling
Configuring Layer 2 Protocol Tunneling on the Switch
Clearing Layer 2 Protocol Tunneling Statistics
To clear the Layer 2 protocol tunneling statistics on a port or on all the tunneling ports, perform this task
in privileged mode:
This example shows how to clear the Layer 2 tunnel port statistics on port 7/1:
Console> (enable) clear l2protocol-tunnel statistics 7/1
Layer 2 Protocol Tunnel statistics cleared on ports: 7/1.
Console> (enable)
Task Command
Clear Layer 2 tunnel port statistics. clear l2protocol-tunnel statistics [mod/port]
To Next Page
Loading...
Need help?
General