27-20
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 27 Working with System Software Images
Downloading the System Software Images Using rcp
Single Module Image rcp Download Example
Note For a procedure on downloading the software images to the intelligent modules, see the “Downloading
the Switching Module Images Using rcp” section on page 27-17.
This example shows a complete rcp download procedure of an ATM software image to a single ATM
module:
Console> (enable) show version 4
Mod Port Model Serial # Versions
--- ---- ---------- --------- ----------------------------------------
4 1 WS-X6101 003414855 Hw : 1.2
Fw : 1.3
Sw : 3.2(6)
Console> (enable) copy rcp 4/flash
IP address or name of remote host []? 172.20.52.3
Name of file to copy from []? cat6000-atm.3-2-7.bin
Download image rcp:cat6000-atm.3-2-7.bin to Module 4 FLASH (y/n) [n]? y
This command will reset Download Module(s) you selected.
Do you wish to continue download flash (y/n) [n]? y
Download done for module 4, please wait for it to come online
File has been copied successfully.
Console> (enable) 09/2/1999,13:13:54:SYS-5:Module 4 is online
Console> (enable) show version 4
Mod Port Model Serial # Versions
--- ---- ---------- --------- ----------------------------------------
4 1 WS-X6101 003414855 Hw : 1.2
Fw : 1.3
Sw : 3.2(7)
Console> (enable)
Multiple Module Image rcp Download Example
Note For a procedure on downloading the software images to the intelligent modules, see the “Downloading
the Switching Module Images Using rcp” section on page 27-17.
To Next Page
Loading...
