EasyManuals Logo
Home>Cisco>Switch>WS-C6506

Cisco WS-C6506 User Manual

Cisco WS-C6506
1488 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #948 background imageLoading...
Page #948 background image
39-14
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 39 Configuring the Switch Access Using AAA
Configuring Authentication on the Switch
This example shows how to enable local login, enable authentication for both console and Telnet
connections, and verify the configuration:
Console> (enable) set authentication login local enable
local login authentication set to enable for console and telnet session.
Console> (enable) set authentication enable local enable
local enable authentication set to enable for console and telnet session.
Console> (enable) show authentication
Login Authentication: Console Session Telnet Session
--------------------- ---------------- ----------------
tacacs disabled disabled
radius disabled disabled
kerberos disabled disabled
local enabled(primary) enabled(primary)
Enable Authentication: Console Session Telnet Session
---------------------- ----------------- ----------------
tacacs disabled disabled
radius disabled disabled
kerberos disabled disabled
local enabled(primary) enabled(primary)
Console> (enable)
Setting the Login Password
The login password controls access to the user mode CLI. The passwords are case sensitive, contain up
to 19 characters, and use any printable character including a space.
Note The passwords that were set in releases prior to software release 5.4 remain non-case sensitive. You must
reset the password after installing software release 5.4 to activate case sensitivity.
To set the login password for local authentication, perform this task in privileged mode:
This example shows how to set the login password on the switch:
Console> (enable) set password
Enter old password: <old_password>
Enter new password: <new_password>
Retype new password: <new_password>
Password changed.
Console> (enable)
Task Command
Set the login password for access. Enter your old
password (press Return on a switch with no
password configured), enter your new password,
and reenter your new password.
set password

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WS-C6506 and is the answer not in the manual?

Cisco WS-C6506 Specifications

General IconGeneral
BrandCisco
ModelWS-C6506
CategorySwitch
LanguageEnglish

Related product manuals