Copyright 2013 Baker Hughes Company.
160 | DPI620G Instruction Manual–English
Chapter 10. FOUNDATION™ Fieldbus
10.15.2 Options
10.15.3 Advanced
These settings are for advanced users only and it is recommended to keep default values.
Option Description
Poll header every Sets the refresh rate for the device parameters shown in the header.
Poll all dynamic every Sets the refresh rate for FF dynamic variables in the function group
view (note this setting only becomes valid if the function group option
Refresh Vars On is active). Refer to Section 10.10.
Enable Device Library Monitor If checked, enables the automatic check of the Open Field
Communications (OFC) DD library on application start up for new
Device Descriptions. Note this configuration option requires a network
path to the Internet. After installation, the default setting is ‘checked’.
Confirm Device Commits If checked, brings up a confirmation dialog before every write is
committed to the field device. After installation, the default setting is
‘checked’.
Enable My Device Functions Enables the ‘My Device’ and Export to DPI620G functions. After
installation the default setting is ‘checked’.
Enable Value Range Checking If checked, makes sure that all variable edits are within the limits
specified by the device. After installation, the default setting is
‘checked’.
Enable Function Blocks If checked, function blocks are enabled. After installation, the default
setting is ‘unchecked’.
Enable Transducer Blocks If checked, transducer blocks are enabled. After installation, the default
setting is ‘checked’.
To Next Page
Loading...
Need help?
General
