To Next Page

To Previous Page

EMC VNX VG2/VG8 Gateway Configuration Setup Guide

302

Navisphere Manager procedures

EMC CONFIDENTIAL

Collecting backend WWNs

The blade and array Fibre Channel ports must connect to the same switch or

switches. The switch zoning determines which ports can connect to each other.

Note: Zone the switches by World Wide Name (WWN) and not by port.

You can usually get the WWNs of the array ports using a monitor or listing menu of

the Fibre Channel switch administration program.

You can also get the WWNs (also called SP UIDs) for arrays by using Navisphere

Manager as shown in Figure 177. On the main Navisphere Manager page, expand the

tree under the array name. The WWNs for each SP port are listed under Physical >

Enclosure > SPs > SP A and SP B.

Figure 177 WWNs displayed in Navisphere Manager

Questions and Answers:

Need help?

Do you have a question about the EMC VNX VG2 and is the answer not in the manual?

EMC VNX VG2 Specifications

General