Navigation tools •
••
• 221
Move EBL/parallel index:
Use this option to move EBL/parallel index. To change direction of EBL use CHART ALIGN push button. Move
cursor to end of EBL, drag and drop it to desired location by using CHART ALIGN push button.
sheet: "TOOL SET 2"
There is a possibility to set another tool. It is used same way as TOOL SET 1.
How to move EBL
You have two methods available: you can directly enter a new numeric value of EBL or you can locate cursor over
the EBL line and use CHART ALIGN to move it. If you locate cursor over crossing of VRM and EBL then you can
use CHART ALIGN to move both. If reference point and EBL coexist in a same location then you can set
preference to move EBL with "Move VRM" option.
How to move VRM
You have two methods available: you can directly enter a new numeric value of VRM or you can locate cursor over
the VRM ring and use CHART ALIGN to move it. If you locate cursor over crossing of VRM and EBL then you
can use CHART ALIGN to move both. If reference point and VRM coexist in a same location then you can set
preference to move VRM with "Move VRM" option.
How to move Reference point
To move reference point, move cursor above reference point and use CHART ALIGN push button to drag and drop
reference point desired location. If reference point, EBL and VRM coexist in a same location then you can set
preference to move Reference point with "Move Reference point" option
Centered reference point with Variable Range Mark (VRM), Electronic Bearing Line (EBL) and numeric info on chart display.
To Next Page
Loading...
Need help?
General
