Route planning •
••
• 233
Change waypoint position
To change position of waypoint you have following alternatives to do it:
• Enter latitude and longitude to Position field.
• Drag and drop waypoint with CHART ALIGN push button.
Enter latitude and longitude to Position field:
1. Select Waypoints sheet open.
2. Select desired Waypoint.
3. Enter co-ordinates of latitude and longitude to Position field. To modify co-ordinate of
Latitude take cursor to Lat edit box and press Select button. Enter co-ordinate and press OK.
To the same way to modify co-ordinate of longitude.
Drag and drop waypoint to new position:
CHART ALIGN pushbutton
1. Select Waypoints sheet open.
2. Take cursor into the Electronic chart area above desired waypoint.
3. Press CHART ALING push button and move cursor to desired position.
Keep CHART ALIGN button pressed down while you move cursor and
release it when cursor is in right position.
Drag and drop waypoint to new position. In this case it is waypoint number 39 to take to new position.
To Next Page
Loading...
Need help?
General
