SD Card Appli Move
D255/D256/M281/M282 2-122 SM
2.17.3 MOVE EXEC
The menu "Move Exec" (SP5-873-001) lets you copy application programs from the original SD
card to another SD card.
 Do not turn ON the write protect switch of any application SD card. If the write protect
switch is ON, a download error (e.g. Error Code 44) occurs during a firmware upgrade or
application merge.
1. Turn OFF the main power.
2. Make sure that an SD card is in SD Card Slot 1. The application program is copied to
this SD card.
3. Insert the SD card (having stored the application program) in SD Card Slot 2. The
application program is copied from this SD card.
4. Turn ON the main power.
5. Enter the SP mode.
6. Select SP5-873-001 "Move Exec".
7. Follow the messages shown on the operation panel.
8. Turn OFF the main power.
9. Remove the SD card from SD Card Slot 2.
10. Turn ON the main power.
11. Check that the application programs run normally.
2.17.4 UNDO EXEC
The menu "Undo Exec" (SP5-873-002) lets you copy back application programs from an SD card
to the original SD card. You can use this program when, for example, you have mistakenly copied
some programs by using Move Exec (SP5-873-001).
 Do not turn ON the write protect switch of any application SD card. If the write protect
switch is ON, a download error (e.g. Error Code 44) occurs during a firmware upgrade or
application merge.
1. Turn OFF the main power.
2. Insert the original SD card in SD Card Slot 2. The application program is copied back
into this card.
3. Insert the SD card (having stored the application program) in SD Card Slot 1. The
application program is copied back from this SD card.
4. Turn ON the main power.
5. Enter the SP mode.
6. Select SP5-873-002 "Undo Exec".
7. Follow the messages shown on the operation panel.
To Next Page
Loading...
Need help?
General