Main Machine Installation
D255/D256/M281/M282 2-14 SM
2.2.6 SETTINGS ACCORDING TO THE SERVICE CONTRACT
Change the necessary settings depending on the customer's service contract.
Meter Click Charge
There are two ways to set up this function.
 Meter click charge enabled (SP5-930-001 set to "1 (enabled)"; this is the default
setting): The counter can be displayed and printed by the customer. The service
representative can then call the customer and ask for the counter.
 Meter click charge disabled (SP5-930-001 set to "0 (disabled)"): The counter cannot be
displayed or printed by the customer. To check the counter, the service representative must
print the SMC report (SP 5-990).
Item SP No. Function Default
Meter Click Charge SP5-930-001
Enables or disables Meter Click
Charge.
When enabled:
 The counter menu shows
immediately after you push the
"Menu" key.
In MP 501/601, "Counter Method"
(SP5-045-001) sets the type of
the counter.
 You can print the counter from the
counter menu.
When disabled:
 The counter menu does not show.
1: ON
Meter Click Charge:
Maintenance Kit
SP5-931-001
Enables or disables the PM alert for
the maintenance kit.
* This setting is unnecessary with this
machine since this machine does not
have the maintenance kit.
1: No
alert
To Next Page
Loading...
Need help?
General