Security Setting
SM 2-145 D255/D256/M281/M282
2.23.4 HDD ENCRYPTION (MP 501/601)
Before You Begin the Procedure:
1. Make sure that the following settings (1) to (3) are not at their factory default values.
(1) Supervisor login password
(2) Administrator login name
(3) Administrator login password
If any of these settings are at their factory default values, tell the customer that these settings
must be changed before you do the installation procedure.
2. Make sure that "Admin. Authentication" is on.
[User Tools] -> [Machine Features] -> [System Settings] -> [Administrator Tools] ->
[Administrator Authentication Management] -> [Admin. Authentication]
If this setting is off, tell the customer that this setting must be on before you do the installation
procedure.
3. Make sure that "Administrator Tools" is enabled (selected).
[User Tools] -> [Machine Features] -> [System Settings] -> [Administrator Tools] ->
[Administrator Authentication Management] -> [Available Settings]
If this setting is disabled (not selected), tell the customer that this setting must be enabled
(selected) before you do the installation procedure.
To Next Page
Loading...
Need help?
General