www.trilithic.com
Page II-61
180 DSP Operation Manual
Signal Level Meter
Create a New Limit Set
Perform the following steps to create a new limit set:
1. Select the File softkey.
2. From the File pop-up menu, select
the New button as shown in the
image to the right.
3. The Continue window will be
displayed as shown in the image to
the right.
4. Select the OK button to continue
or select the Cancel button to exit
without creating a new limit set.
5. Use the Virtual Keyboard to enter
the name of the new limit set as
shown in the image to the right.
To Next Page
Loading...
Need help?
General
