www.trilithic.com
Page II-28
180 DSP Operation Manual
Signal Level Meter
Flashlight Delay
The Flashlight Delay setting is used to
conserve power by automatically turning
off the LED ashlight after a specied
period of time.
The default setting for the ashlight delay
is 30 Seconds. The ashlight delay can
be set from a minimum of 30 seconds up
to a maximum of 180 seconds.
Use either of the following methods to
change the ashlight delay:
• Use the up/down arrow buttons
to change the value in 30 second
increments.
• Press the Enter button and use the
Virtual Keyboard to directly enter
the ashlight delay as shown in the
image to the right.
Keypad Beeps
The Keypad Beeps setting is used to
enable or disable keypad beeps for the
internal speaker.
The default setting for Keypad Beeps is
Yes, use the up/down arrow buttons to
select from the following preset values:
• Select Yes to hear the keypad
beeps.
• Select No to mute the keypad
beeps.
To Next Page
Loading...
Need help?
General
