Trilithic 180 DSP User Manual

www.trilithic.com
Page I-24
180 DSP Operation Manual
Signal Level Meter
Sleep Mode
The sleep mode is used to conserve power by putting the 180 DSP to sleep when not in
use. This also allows the 180 DSP to be turned back on quickly when moving from one test
location to another throughout the work day
Automatic Sleep Mode
The 180 DSP will automatically enable the sleep mode to conserve power after the 180
DSP has been idle for a specied period of time.
The default setting for the sleep mode delay is 5 Minutes. The sleep mode delay can be
set from a minimum of one (1) minute up to a maximum of 60 minutes.
Manual Sleep Mode
To manually enter the sleep mode, quickly press the Power button.
Wake from Sleep Mode
Quickly Press the Power button to wake the 180 DSP from sleep mode. The sleep
mode delay timer will automatically restart.
For more information about setting the Sleep Mode Delay, see
Section II: Setup, Chapter 3: Meter Conguration, Interface
Settings.
Whenever the 180 DSP is being powered by the AC to DC
power adapter & battery charger, the sleep mode delay will be
deactivated automatically.

Trilithic 180 DSP Specifications

General

Brand	Trilithic
Model	180 DSP
Category	Measuring Instruments
Language	English