www.trilithic.com
Page III-15
180 DSP Operation Manual
Signal Level Meter
If there is more than one channel plan on the 180 DSP, the Channel Plan window will be
displayed as shown in the image below (left). Select the name of the channel plan that you
would like to assign to the selected job.
If there is only one channel plan on the 180 DSP, the Channel Plan window will be skipped
and that channel plan will automatically be assigned to the channel plan.
Once you have selected the channel plan, the Job Management screen will automatically
refresh to display the new channel plan assignment as shown in the image below (right).
Changing Comments of an Existing Job
This function is used to change the
comments of the selected job. Highlight
the job that you would like to change the
comments for as shown in the image to
the right.
To Next Page
Loading...
Need help?
General
