Trilithic 180 DSP User Manual

www.trilithic.com
Page II-32
180 DSP Operation Manual
Signal Level Meter
Job & Workorder ID Length
The Job/Workorder ID Length setting
is used to set the maximum number
of characters to display for jobs and
workorders on the 180 DSP.
The default setting for the job and
workorder ID length is 6 Characters.
The character length can be set from
a minimum of 6 characters up to a
maximum of 32 characters.
Use either of the following methods
to change the maximum number of
characters:
• Use the up/down arrow buttons
to change the value in one (1)
character increments.
• Press the Enter button and use
the Virtual Keyboard to directly
enter the number of characters
as shown in the image to the
right.

Trilithic 180 DSP Specifications

General

Brand	Trilithic
Model	180 DSP
Category	Measuring Instruments
Language	English