7-10 WorkCentre C2424 Service Manual
Lubrication
The system is lubricated during assembly at the factory and requires no periodic
lubrication. Certain system components require lubrication following replacement.
These parts are identified in the replacement procedures. When lubricating during
replacement, use the grease approved for the WorkCentre C2424 system. The grease
part number is 006-7997-00.
Caution
Plastic parts will deteriorate when unspecified grease and chemicals are used,
such as WD-40® and Locktite® Threadlocker. To avoid damage, use only the
grease specified in the Lubrication section of the Service Manual.
To Next Page
Loading...
Need help?
General