Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
105
Wide Area Networks (WANs)
The AnywhereUSB Plus device is preconfigured with one Wide Area Network (WAN), named ETH1, and
one Wireless Wide Area Network (WWAN), named Modem.
You can modify configuration settings for the existing WAN and WWANs, and you can create new WANs
and WWANs.
This section contains the following topics:
Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs) 106
Configure WAN/WWAN priority and default route metrics 106
WAN/WWAN failover 109
Configure SureLink active recovery to detect WAN/WWAN failures 110
Configure the device to reboot when a failure is detected 118
Disable SureLink 127
Example: Use a ping test for WAN failover from Ethernet to cellular 130
Using Ethernet devices in a WAN 133
Using cellular modems in a Wireless WAN (WWAN) 133
Configure a Wide Area Network (WAN) 155
Configure a Wireless Wide Area Network (WWAN) 162
Show WAN and WWAN status and statistics 172
Delete a WAN or WWAN 174
Default outbound WAN/WWAN ports 175
To Next Page
Loading...
Need help?
General