Digi AnywhereUSB Plus User Manual

Configuration and management Review AnywhereUSB Plus default settings
AnywhereUSB® Plus User Guide
80
Review AnywhereUSB Plus default settings
You can review the default settings for your AnywhereUSB Plus device by using the local WebUI or Digi
Remote Manager:
Local WebUI
1. Log into the AnywhereUSB Plus WebUI as a user with Admin access. See Open the web user
interface for details.
2. On the menu, click System > Device Configuration.
Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. Click Device Management to display a list of your devices.
3. Locate and select your device as described in Use Digi Remote Manager to view and manage
your device.
4. Click Configure.
The following tables list important factory default settings for the AnywhereUSB Plus.
Default interface configuration
Interface type
Preconfigured
interfaces Devices Default configuration
Wide Area Networks (WANs)
(Available only on the
AnywhereUSB Plus 8 and 24
models.)
n
Modem
n
WWAN1
cellular
modem
n
Firewall zone: External
n
WAN priority: Metric=3
n
SIM failover after 5
attempts
Ethernet Network
n
ETH1
n
Ethernet:
ETH1
n
Firewall zone: Edge
n
DHCP client enabled
n
Loopback
n
Ethernet:
Loopback
n
Firewall zone:
Loopback
n
IP address: 127.0.0.1/8
n
Default IP
n
Ethernet:
ETH1
n
Firewall zone: Setup
n
IP address
192.168.210.1/24
n
Default Link-local
IP
n
Ethernet:
ETH1
n
Firewall zone: Setup
n
IP address
169.254.100.100/16
n
ETH2
(Available on the
AnywhereUSB Plus
24 model only.)
n
Ethernet:
ETH2
n
Firewall zone: Edge
n
DHCP client enabled

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English