Digi AnywhereUSB Plus User Manual

Central management Enable event log upload to Digi Remote Manager
AnywhereUSB® Plus User Guide
462
Enable event log upload to Digi Remote Manager
You can configure your device to upload the event log to Digi Remote Manager, and configure the
interval between event log uploads.
To enable the event log upload, or disable it if it has been disabled, and to change the upload interval:
ÉWebUI
1. Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Monitoring > Device event logs.
4. Click Enable event log uploads.
5. For Device event log upload interval, select the interval between health sample uploads.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Device health data upload is enabled by default. To enable or disable:
n
To enable:
(config)> monitoring events enable true
(config)>

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English