Services Location information
AnywhereUSB® Plus User Guide
253
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the GNSS module:
n
To enable the module:
(config)> service location gnss true
(config)>
n
To disable the module:
(config)> service location gnss false
(config)>
4. Set the amount of time that the AnywhereUSB Plus device will wait before polling location
sources for updated location data:
(config)> service location interval value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config)> service location interval 600s
(config)>
The default is 10 seconds.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the device to use a user-defined static location
You can configured your AnywhereUSB Plus device to use a user-defined static location.
ÉWebUI
To Next Page
Loading...
Need help?
General