Command line interface Command line reference
AnywhereUSB® Plus User Guide
739
Replace a group
This example replaces the group at index 0 with group 2. The client must have at least one group
already assigned.
config service anywhereusb clients 0 groups 0 group02
Delete a client
You must specify the index of the client (0-254) to delete it.
> config
(config)> del service anywhereusb clients (6)
(config)> save
USEALLHUBADDRS
Enable or disable the AnywhereUSB Manager from connecting to extra IPaddresses.
The AnywhereUSB Hub may have default IP addresses that are reported by mDNS to the
AnywhereUSB Manager, but in many network environments, the Manager cannot connect to them.
As part of normal operation, the Manager tries to sequentially connect to all of the Hub IP addresses,
so if it starts trying these extra default IP addresses, it may take extra time (minutes) for the Manager
to connect or reconnect.
By default, this option is deselected and the Manager does not attempt to connect to these
addresses.
Note This can also be done in the Preferences dialog. See Use all Hub addresses.
USEALLHUBADDRS,[on|off]
Parameters
n
off: Disable the Use All Hub Addresses option. The AnywhereUSB Manager will not attempt
to connect to the extra IP addresses. This is the default.
n
on: Enable the Use All Hub Addresses option. The AnywhereUSB Manager will attempt to
connect to the extra IP addresses.
To Next Page
Loading...
Need help?
General