Firewall Configure custom firewall rules
AnywhereUSB® Plus User Guide
389
src_zone external
(config)>
4. To delete the rule, use the index number with the del command. For example:
(config)> del firewall filter 1
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure custom firewall rules
Custom firewall rules consist of a script of shell commands that can be used to install firewall rules,
ipsets, and other system configuration. These commands are run whenever system configuration
changes occur that might cause changes to the firewall.
To configure custom firewall rules:
ÉWebUI
1. Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Custom rules.
4. Enable the custom rules.
5. (Optional) Enable Override to override all preconfigured firewall behavior and rely solely on
the custom firewall rules.
6. For Rules, type the shell command that will execute the custom firewall rules script.
To Next Page
Loading...
Need help?
General