Services Configure DNS
AnywhereUSB® Plus User Guide
237
5. Click SSH keys.
6. In Add SSH key, enter a name for the SSHkey and click g.
7. Enter the public SSH key by pasting or typing a public encryption key that this user can use for
passwordless SSH login.
8. Click Apply to save the configuration and apply the change.
Command line
You can add configure passwordless SSH login for an existing user or include the support when
creating a new user. See User authentication for information about creating a new user. These
instructions assume an existing user named temp_user.
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add an SSH key for the user by using the ssh_key command and pasting or typing a public
encryption key:
(config)> add auth user maria ssh_key key_name key
(config)>
where:
n
key_name is a name for the key.
n
key is a public SSH key, which you can enter by pasting or typing a public encryption
key that this user can use for passwordless SSH login
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure DNS
The AnywhereUSB Plus device includes a caching DNS server which forwards queries to the DNS
servers that are associated with the network interfaces, and caches the results. This server is used
To Next Page
Loading...
Need help?
General