Services Configure the ping responder service
AnywhereUSB® Plus User Guide
304
Configure the ping responder service
Your AnywhereUSB Plus device's ping responder service replies to ICMP and ICMPv6 echo requests.
The service is enabled by default. You can disable the service, or you can configure the service to use
an access control list to limit the service to specified IP address, interfaces, and/or zones.
To enable the iPerf3 server:
ÉWebUI
1. Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Ping responder.
The ping responder service is enabled by default. Click Enable to disable all ping responses.
4. Click to expand Access control list to restrict ping responses to specified IP address,
interfaces, and/or zones:
n
To limit access to specified IPv4 addresses and networks:
a. Click IPv4 Addresses.
b. For Add Address, click g.
c. For Address, enter the IPv4 address or network that can access the device's ping
responder. Allowed values are:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the ping responder.
d. Click gagain to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
a. Click IPv6 Addresses.
b. For Add Address, click g.
c. For Address, enter the IPv6 address or network that can access the device's ping
responder. Allowed values are:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the ping responder.
d. Click gagain to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the AnywhereUSB
Plus device:
a. Click Interfaces.
b. For Add Interface, click g.
To Next Page
Loading...
Need help?
General