Digi AnywhereUSB Plus User Manual

Central management Add a device to Digi Remote Manager
AnywhereUSB® Plus User Guide
465
Add a device to Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. Click Device Management to display a list of your devices.
3. Click Add Devices.
4. Select MAC Address and enter the Ethernet MAC address for your device.
5. For Install Code, enter the default password on the printed label packaged with your device.
The same default password is also shown on the label affixed to the bottom of the device.
6. Click Add.
7. Click OK.
Digi Remote Manager adds your AnywhereUSB Plus device to your account and it appears in the
Device Management view.
View Digi Remote Manager connection status
To view the current Digi Remote Manager configuration:
ÉWebUI
1. Log into the AnywhereUSB Plus WebUI as a user with Admin access.
2. The dashboard includes a Digi Remote Manager status pane:
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. View the central management configuration:
(config)> show cloud
drm
cellular_keep_alive 290s
drm_url my.devicecloud.com
keep_alive 60s
keep_alive_misses 3
retry_interval 30s
enable true
(config)>
1. Type cancel to exit configuration mode:
(config)> cancel
>

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English