Configure the AnywhereUSB Manager from the command line device info
AnywhereUSB® Plus User Guide
752
device info
Purpose
Displays information about a device. For more information, see AnywhereUSBManager USB Device
Status pane.
Syntax
>awusbmanager device info,<address>
The [address] is the address of the device for which you want to display information. The address is
required.
Examples
Run the list command to determine the device's address.
AnywhereUSB Manager, below are the available devices:
AW02-000001 (AW02-000001.local.:18574)
* Group 2 (AW02-000001.2) (In-use by you)
* Group 1 (AW02-000001.1) (In-use by you)
+ U3 Cruzer Micro "USB stick 1" (AW02-000001.1101) (In-use by you)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
Run the device info command.
>awusbmanager device info,AW02-000001.1101
Information about the device displays.
ADDRESS: AW02-000001.1101
LOCALNAME: USBîŻstick 1
VENDOR: SanDisk
VENDOR ID: 0x0781
PRODUCT: U3 Cruzer Micro
PRODUCT ID: 0x5406
SERIAL: 0770000F0000000C
PORT ONîŻHUB: 2
AUTOCONNECT: inherited
IN USE BY: YOU
To Next Page
Loading...
Need help?
General