Configure the AnywhereUSB Manager from the command line list
AnywhereUSB® Plus User Guide
771
list
Purpose
Displays a list of Hubs, groups, and devices on the network as well as any Hubs the
AnywhereUSBManager knows about.
Note This information is similar to what displays in the AnywhereUSBManager. See AnywhereUSB
Manager window.
If a group has auto connect enabled, an asterisk displays next to the group name.
Additional information about features displays at the bottom of the list:
n
Status of the auto-find feature: enabled or disabled.
n
Status of the auto connect all feature: enabled or disabled.
n
Specifies whether the AnywhereUSB Manager is running as a service.
Syntax
>awusbmanager list
Examples
This example shows one Hub: AW02-000001. If assigned, the local name for the Hub displays
surrounded by quotes: "Hub 1".
On the Hub, Group 1 has the auto connect feature enabled, as specified by the asterisk next to the
group name.
The address for each group is in parentheses after the group name. In this example the address for
Group 1 is AW02-000001.1.
The address for a device is in parentheses after the device name. In this example the address for the
US Cruzer Micro device is AW02-000001.1101.
AnywhereUSB Manager, below are the available devices:
AW02-000001 "Hub 1" (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
* Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
To Next Page
Loading...
Need help?
General