Configure the AnywhereUSB Manager from the command line connect device
AnywhereUSB® Plus User Guide
749
connect device
Purpose
Connect to a USB device in a group to which you have access. You cannot connect to a device in a
group that is already in use.
You must be connected to the group before you can connect to a device in that group. If the device
requires a password, you must enter the password when using the connect device command.
Syntax
>awusbmanager connect device,<address>[,password]
The <address> is the address of the device to which you want to connect. Run the list command to get
the device address.
The <password> is the password for the device. The password is optional.
Examples
If you have connected to a group, and then disconnect from a device in that group, you no longer
have access to the device. You can reconnect to that device.
Run the list command to make sure you are connected to the group that the device you want to
connect to is in. In this example, the device is in Group 1, so you should be connected to Group 1.
You will need the address for device to which you want to connect.
AnywhereUSB Manager, below are the available devices:
AW02-000001 (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
Run the connect device command. If required to access the device, include the device password.
>awusbmanager connect device,AW02-000001.1101
Run the list command again to verify that the device is connected.
AnywhereUSB Manager, below are the available devices:
AW02-000001 (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101) (In-use by you)
* means Autoconnect enabled, + means Autoconnect inherited
To Next Page
Loading...
Need help?
General